BestTeam 10PCS T-Slider for T-Slot, M6M8 T-Track Slider Sliding Nut Aluminum Alloy T Slot Nut for Woodworking Tool Jigs Screw Slot Fastener (M5), Sliver

I ordered an odd size t track so these were for me to cut to fit for my own application. Durable, standard track size and easy to cut down lol. Good product really.

I used these in a sprinter stock roof rack to attach to the roof. They were the nuts. They fit the aluminum rails perfectly after some removal of the nylon material at the end where you slide them into the rack.

There fine, work just as they should and they fit into standard 3/4 track. Just need to supply your own metric bolt.

I needed more T-sliders for my Shopsmith. I wasn't willing to pay $5.99 a piece (plus shipping), so I looked on Amazon. According to my measurements these would fit. Well, they were just a little too wide, but a few minutes with a bastard file and they fit wonderfully. I will buy them again if I need more.

Fit just right on Craftsman cast iron table saw M#315.228390 (year 2000). This "T" nut I order is 8mm thread, not US thread, made out of aluminum. Gave 3 stars due to thread size.

GOOD PRODUCT

Promoted for woodworking but these won't fit any standard woodworking track. Check the dimensions...

As previously reviewed, these will work on Shopsmith (500-520). The wider base will fit in the "T" track with no problem (in width and thickness). You just need to file the sides of the narrower part so it will fit the upper part of the track. Overall height is at or just below the track which means you don't need file the top down. Dimensions (see pic) L: 1-3/16" , width-outer: 29/32", width-inner: 3/4", height: 5/16", T-rail height: 1/8" Thread Pitch 1.25 (standard)