JFG RACING Motorcycle Dirt Bike Stand 1000Lbs Capacity Lift Jack Hoist Table Height Adjustable Lifting Stand Ideal for Dirt Pit Bike Repair&Maintainance,Dirt Bike Accessories

worked as expected, better then the old style with pin to keep bike up. no issues and bike sets stable enough to do what is needed for normal MTC. I would by again with reasonable price and good quality.

Gets the rear off the ground, but not the front without it being too unstable and the whole thing toppling over. Needs a wider base and a few more threads. But otherwise serve its purpose. Be perfect for a smaller bike, not a 300.

I used this to change out the rear monoshock, adjust front shock collar height, and clean the wheels and chain on my Honda CRF250 Rally.The build quality is cheap and cheerful. The rubber nonmark/nonskid lifting surface is thick, tough and well-adhered. The lifting handle and lowering piston are effective.The weld quality is indifferent. When I tapped the pin on the locking collar with a hammer, the pin broke off.The tolerance in the central shaft and the lifting pad is far too loose!The bike went up easily enough, but rested at an angle. Fortunately this stand is not very expensive. My bike comes off the ground safely and easily when the lifting pad is wound out (and locked) about an inch. Any higher than that and the stand would not be safe.

Simple and easy to useI really like the swivel aspect of itIt has a nice little safety latch to prevent it from coming back down

this is the worst stand i’ve ever bought, first off straight out of the box the paint was so thick that the pins didn’t go through the holes to connect the lift arm to the lift so i used a drill bit to widen the holes a little bit and take the paint off some. this worked but then i put the stand down to find out the stand doesn’t go high enough even for a 125!! HELLO? Who in gods name makes a dirtbike life that goes up 4 inches like it’s seriously annoying, i’m sorry to anyone that bought this PLEASE DONT BUY!!!!!! written on September 6th 2020.

For the good, the stand is solid, and allows me to lift my 90Lb electric bike easily. It also lets it go down slowly and smoothly when I release the lift, thank to the damper shock.You do want to make sure that once you have the platform height set to match the unlifted bike, you tighten the counter screw, so the platform does not wobble.For the not so good, the item I received was clearly open box, and the box was half torn apart and fixed up with Tape.Worse, it was missing the two axial bolts and buckles needed to assemble the lever to the stand. I contacted the seller JFG racing twice asking if they could send me the missing bolts, and got no answer whatsoever.Given I had some threaded bolts of the right size laying around, I fixed it rather than sending it back, but a bad mark for the company who does not seem to care.So the stand is good, but it is available from several different vendors, so you may want to take your chance with a different one :)

This is not a hydraulic jack although it appears as be. It is basically a platform that you can set to two levels, up or down. It works well for my stand up e-scooters and I mostly knew this before buying it so it would be unfair to remove points (stars) due to this “feature”. I like it, would buy it again but my point is to help others from being surprised by the fact that this is not a hydraulic jack that you “pump up to whatever level you want. You put it on the lower level, get your vehicle over the platform then push down on the “arm lever” to get it to the higher level and then place a cotter pin type device to maintain that position. That’s it.

Return didn’t work on my bike. It’s for dirt bikes