ineo M.2 NVMe SSD Enclosure Built-in Cooling Fan [C2598-NVMe Series] (10Gbps)

I have a fully-functional extra M.2 NVMe 1TB SSD drive left over from a "warrantee repair" that Dell did for my Precision 7510 laptop, so I thot it would be nice to convert it into an external drive for massive backups. The Dell supports the full USB-C 3.x Thunderbolt spec, and has a port for it.Summary: after assembly and finagled startup, the drive works GREAT ... I copied a folder that had 67.1 GB, in 77 folders and 13,237 files, in a bit less than 5 minutes. Whee! Try that with a typical USB stick, and you'll be waiting for an hour or two.I'm impressed with the housing (see snapshot). It is precision-machined metal, with deep fins for heat control ... important since if the SSD overheats, the transfer rate slows. It is small but heavy ... weighs about the same as my iPhone 7+ with case. My guess is that I could drive a car over it without damaging it.This beastie even has a (cool-looking) built in fan ... which didn't kick on during my initial tests (I'm assuming that it's not broken ... I would have been concerned if it activated for the brief time I tested it). There were NO other NVMe SSD housing options with a fan, and few with beefy fins. This guy is definitely the best in that department.Another nifty feature is a tiny switch to the left of the blue light, which allows you to "lock" the drive so that it is Read-Only vs Read-Write. Nice feature ... again, I didn't see it on other offerings.The connection-cord is "universal" ... for either USB-C (aka Thunderbolt) plug with rounded edges, or a traditional larger square-edged USB-A port. Of course, the speed of the USB-A depends on the guts of the computer. It's all one cable (handy) ... a small converter plug on the end converts from the cable's USB-A to a USB-C plug. The snapshot shows it in place.A thoughtful feature is the inclusion of a drawstring bag that has plenty of room to hold the enclosure, the cable, and maybe a few extra typical-size USB sticks. I like this attention to detail.ISSUES: all minor but just sayin' ...1. there are five teeny-tiny machine-screws provided ... one is a bit larger than the others. The "large" screw is used to hold the SSD in place when you press it down; the other four are used to attach the top to the bottom of the case. I very nearly ordered a replacement, when I couldn't find the fifth "large" screw ... filled out the form, etc, then started to re-box it ... and behold! the screw came out of hiding. Friendly Amazon agent on the phone cancelled the return for me.2. A screwdriver was provided ... and much to my pleasure, it was slightly magnetic at the tip, so it made it easy to "grab" the screws and get them positioned. I didn't realize this at first ... the screws are way too tiny to pick up with fingers ... I had gotten out my tweezers to do it - then I noticed the screwdriver was magnetic.3. The "instructions" are minimal ... reasonable, since the install is really simple. But it would have been nice if they mentioned the magnetic feature. Also ... there is a "silicon pad" that they provide, to place between the top of the installed SSD, and the bottom of the big upper cover of the unit ... presumably to insulate the exposed traces on the SSD from the metal cover. The instructions do NOT mention that you're supposed to peel off a clear strip from one side, so adhesive holds it in place on the SSD.4. Initial Operation was a bit bumpy. I booted the PC, and then plugged in the drive. Note that the PC already has another identical drive SSD as drive C, so I was 100% confident that it could "read" this new drive (as long as the enclosure was working). I plugged it in to the USB-C Thunderbolt port, and opened Explorer. At first, it didn't "see" the drive. I jiggled the plugs a little ... I think, though, that Windows was just mulling it over a bit.5. When the drive (E) did finally appear in Explorer, a Windows popup suggested a scan of the drive. I selected the default and it appeared to complete, with a "1024" (GB) on the pane. However, when I tried to double-click open the drive, it said that it was not accessible. I unplugged it and re-plugged it (no Eject option in the tray). Still would not let me access.6. So, I left it plugged in, and rebooted the computer. When I got back to Windows and checked the drive, it was fully accessible. I did a couple of copies from PC>external, using big folders with lots of nesting. Lickety-split! Exactly what I was hoping for. 67.1 GB in less than 5 min!7. Then, while Windows was open, I used the taskbar "Eject" option (which did appear after the reboot) to disconnect the drive. Then I plugged it back in. Immediately, a popup asked me if I wanted to scan it ... I skipped that and immediately the Explorer window appeared. Perfect. Ejected it again.8. This time, I removed the USB-C adaptor, and plugged it in to one of the USB-A ports that I *think* supports full-speed 3.x protocol. I deleted the 67.1 GB folder, and then re-copied it from the PC (using this alternate port). Apparently the PC supported similar speed thru this port, since the copy again only took about 5 min. Interesting note ... the PC's internal fan kicked on for a little while at this point (Xeon processor apparently working hard) ... but the external enclosure fan never did.9. OK, now I repeated step 8, once again deleting the folder, ejecting, and then plugging in the USB-A plug into the other side of the Dell, where (if I recall correctly) the three additional USB-A ports are more conventional non-Thunderbolt spec. This is a three year old machine so I'm not sure what USB level they are. Certainly at least 2.x, maybe 3.0. The tiny "battery" icon on the side of the unit seems to indicate the USB-A port on the left that I just disconnected from, might offer higher power output for devices that draw a lot of current.10. Once again, I copied the 67.1 GB folder. Apparently the USB-A ports on the right edge are a leetle bit slower ... but still, the entire folder copied in just 6 minutes. This would have taken well over an hour using a typical 256 GB flash drive.11. Final test ... and the ONLY SURPRISE. While the drive was connected, after the big folder was copied, I flipped the tiny "lock" switch on the enclosure, which is supposed to make the drive READ-ONLY. After doing that, I tried copying a couple of files, and they DID copy without issues. So ... you can't activate the write-blocking feature *while* the drive is plugged in. When I tried to eject the drive (with the switch still "locked"), it refused to authorize ejection until I turned the switch back to unlocked position. Then it ejected just fine.12. This time, I turned the switch to lock *before* plugging it back in to the machine. The Explorer window opened the same way. When I tried to copy a couple of files, Windows told me the disk is write protected (as it should be). And this time, when I used the Tray Eject feature, it worked fine (with switch in locked position).I hope this "beat it to death" review is helpful to enquiring minds. I'm VERY PLEASED with this product!

I have been running this USB drive enclosure for over 1 year, so far no issues. I have a 4TB m2 drive installed. I backup my PC to this drive every night for the last year. Installation was easy. The drive stays cool as well. I feel there is good value for the money, as it is built with heavy duty, its got some weight to it.

First and foremost, fantastic product. For that price, I did not expect that level of quality. It came wrapped in sealed plastic, and did not give me the impression it was thrown together. It had some weight to it and the packaging was very professional. the enclosure itself felt high quality and not flimsy or thrown together like other products I got in the past. So here are the pros and cons:Pros:Solid enclosure - it fits together perfectly, no gaps and all screw-holes lined up perfectlyComes with everything - It actually comes with the screwdriver, and even a thermal pad so your drive makes contact with the heat sync top.Quiet - seeing a fan, i was afraid it would be loud, but in reality, in a quiet room, I cant hear it right in-front of me.Fast - No issues with speed at all. Its quite fast even though USB3Appearance - It is a good looking enclosure without being hokey. No LEDs, no clear plastic, so it doesnt look like a cheap toy.Cons:The fan guard - this is the only con. The fan guard seems to have been over tightened during manufacturing, and caused the fan not to run. I had to remove the fan guard, flatten the waves in the fan guard, and reinstall it. Because this is affecting the functionality of the device, I had to give it 4 stars. If it was purely visual, I would not care. It was a simple 5 minute fix.Final thought:If you need an external enclosure, simply put, get this one. Its high quality, it cools the drive, and it.s fast. I have bought others, and dollar wise, this one just makes sense. I have only been using it for a day and a half, if anything changes, I will update this review.

I am cheap. And if you are looking around for a sub$50 enclosure, you finally came here. I read every review. Saw that some people must be doing something wrong. Because others are getting speeds like i am.1. It is quiet. I would expect to hear the fan more. But the design is to pull air into the unit and out of the fins, rather than blowing hot air out. This makes it quiet and efficient. BUT, there is still a slight high pitch wine from it. And it seems to stay on/running. I put mine behind the screen and that helped.2. Speeds are great. Just what they promised. My EVO can do more than it can. But this is fine for now and I run FCP through it.3. Construction. Like others say, "It is a tank". Guessing the strong thick metal is how they managed to make it so small.4. Cable is fine. Some people reported the cable is a bottle neck. Not mine.5. Install. Worked great. Easy to install SSD.6. Did not read instantly. Had to follow instructions. Who reads those? I had to. Simple. If you can install an SSD you will figure out the configuration to get it to read.Very happy. Just wish I would have bought a 4gb instead of 2. Like I said, I am cheap.

Title says it all. Used with a 2GB NVM and fan is crazy loud after one month of use. I produce music so this is unacceptable. I’m out of the return window so I disabled the fan by putting a tiny strip of electrical tape over the fan contacts. I’m crossing my fingers this is going to work until I find a reasonably priced fan-less USB4 enclosure.In general, you should stay away from this model and all models that look like it (there are other clones out there). Stick with fan-less units that rely on massive heatsinks/fins instead of dime-store fans.