Cold Rolled Steel A513 Drawn Over Mandrel Round Tubing, ASTM A513, 1" OD, 0.81" ID, 0.095" Wall, 36" Length

Bought this tubing to make skid shoes for my tractor's rear blade. The material is excellent for that use and I wanted to use it in conjunction with "Cold Rolled Steel A513 Drawn Over Mandrel Round Tubing, ASTM A513, 3/4" OD, 0.37" ID, 0.188" Wall, 12" Length " but as luck would have it, the smaller 3/4 OD tube was the exact same size as the ID of the 1-1/4 tubing I bought and would have to be machined to fit.I went to Rural King and bought 3/4 in x 6-1/2 implement pins and used those for the purpose I had intended for the 3/4 OD tubing. Don't pay any attention to the item's image for either of these pieces of tubing since they are substantially thicker than what is being shown.Either way, the tubing is sent rust free and straight. I'm well pleased with this item and more than happy with the price.I was able to use this to make my skid shoes, even with buying some of the other needed items from Rural King, and make two complete sets of skid shoes for $28.00 per set. Compare that to sets being sold on EBay for $180.00 and you are money ahead.

This pipe is exactly as described and fit my needs perfectly.

I used this to extend some oil cooler lines with a .5” union on an old Land Rover.

This is pretty soft steel. Welded easily. It is very consistent OD and ID. No ERW seam. Nearly perfectly concentric/uniform wall thickness. No ovality. 36" length delivered straight too. Only downside, the 7/8" x 3/4" ID I purchased was actually .745". Again, very consistent but not .750". May not matter to you, but for my application I was driving a .750" pin into cut lengths of this tubing, so it was a bad deal. Spent a few hours drilling it out to a full .750". Other than that, good price on a short length. Locally, only available in 20' lengths at almost identical $/ft.

With Prime shipping, it's a good buy, but something like this is more economical if purchased locally. That is, if possible. Now, this is listed as two different lengths. 12 inches long in the header, and, it's OAL (over all length) is listed as 60 inches in the copy. For this price shipped, I expected it to be 12 inches long, which it was. In appearance, it has a standard quality mill finish. It's what you would expect from any established steel vendor.

Pretty simple here. It's a 2 foot chunk of tubing. However it's measurements are good, mikes out right at .65 thickness and is very smooth inside. Being that I was using it to make a custom seatpost for an obsolete electric scooter, and the inside finish was such that I did not have to do much to clean it up, it's basically perfect. OD was right on as well.

This tube has an inside diameter of 15/64", NOT 1/4". I'm sure it is otherwise a fine piece of tubing, but pretty useless when you bought it because you needed something that a 1/4" drill bit would fit through. On the positive side, Amazon was very helpful in letting me return it.

Used for changing size of 10 bolt axle tubes on rear axle to bring them to 3" dimension to add ladder bars. ID fits Chevy 10 bolt axle tubes. I cut this in half lengthwise and welded to stock axle tubes, then mounted coil-over mounts and ladder bars. This material was great for welding.