KW3A Microwave Oven Door Switch 16A 125/250V Door Interloc (2 Normally Open and 1 Normally Closes)

The microwave fan ran whenever the door was open, then that stopped and it didn't cook at all. Figured it was a door switch and replaced all 3, rather than just the broken one, since I had to remove them to test. There are many good repair videos on YouTube, so you can find the one closest to your make/model. Microwave is working fine now. I'll update this review if any of the switches cause trouble, but wanted to post a positive review since it was a quick and easy repair and the switches are perfect.

Came quickly and was an easy fix for my Frigidaire Microwave. Way cheaper that buying a new one.

I ordered the (2 Normally Open and 1 Normally Close) Brand: Yoiilnz three pack and replaced all three switches in my friend's microwave oven. His oven only needed the normally closed switch (The Monitor Switch) in their Frigidaire by Electrolux microwave model FFMV164LSA. These new switches installed without issue, and everything now works as designed. The switches were delivered in two days and appear identical to the original other than color of the plastic. The problem he was having was that as soon as he hit the start button to heat something up it would trip the house circuit breaker. While doing research on the issue the most common cause reported was a broken (Stuck in On position) middle (Monitor switch). That is exactly what I found on his unit. With the monitoring switch in an always on state it causes a direct short which then trips the circuit breaker. I can recommend these aftermarket switches instead of spending 10 times as much for OEM.

Great value, works good

Just like factory set works great on my whirlpool microwave

I replaced the three door switches in a Kenmore Microwave oven (Model NO. 721.69122010). It was the normally open bottom switch that went bad. It operates off the door latch and takes a beating when the door closes. Make sure you unplug the microwave first and then after removing the case cover discharge the big capacitor for the magnetron. Use a long screwdriver with an insulated handle. Short across the capacitor leads and to the case to make sure the capacitor has no charge before sticking your hands in the area of the door switches. The capacitor is in the same area and if its bleeder resistor is burned out or broken the capacitor won't bleed down. It will bite badly if you touch it and it still has a charge. Take a picture of each of the three door switches before removing so you can put the wires back on the terminals correctly. Replace one switch at a time. Be careful with the plastic retaining clips. They won't flex much and will break easily. There is a trick to removing and reinstalling each switch. There is a little plastic post that extends in the hole in one corner of each switch. Carefully lift the front retaining clip on the switch just enough to slide it out slightly swing it down and out and pull it off the post. It's important to not break the post. The removing and installation of each of the three switches is not identical but similar. It's tricky and delicate but can be done without breaking any clips or posts. Install them in reverse order. Do the switches one at a time. It took me about 45 minutes.

The price good

If your microwave blows fuses when you open the door, you need these to fix it!

I purchased the set to repair my Danby Mivrowave that kept running when the door was opened. They were the right size and specification. They microwave functioned normally after the switches were replaced. Good quality, decent price.

Quedo muy bien en mi horno, piezas universales con las que no tienes problema para reemplazar las dañadas

bought for my air fryer, installed it and works like oem part

Working very good. I'm happy with that. Thanks.

Works pefect