Ingersoll Rand Air Hammer Kit 123MAXHK - Powerful Pneumatic Hammer with Anti-Vibration Short Barrel & Quick-Change Retainer, Pack of 2

Definitely does a lot of hard hammering work for difficult to remove bolts / inserts that might be wedged in. Great tool for sure. Functions well and value for money as long as it’s looked after and oiled.

I use these with my Ingersoll air hammer. Used one to chisel a nice small square hole deep through some strong concrete and it did the job perfectly. The others have taken battering through various used on my cars suspension and are holding up well. Seem to be of a high quality and the price isn't bad compared to comparable products. 5/5 - Would recommend

Great tool does the job what suppose to worth every single penny.

Fantastic bit of kit ! I had a seized ball joint taper that had been stuck solid in a steering knuckle lying in the corner of my garage that I had abandoned about 3 years ago. I remember using heat and banging it with a club hammer for ages before I gave up - it was at a very awkard angle to apply any real force.Decided to try my new air hammer on it and after a quick blip of 2 seconds it came out very easily ! And the tool wasnt noisy at all .Very impressed with it

Amazing product really powerful but unfortunately i think its a factory issue as the trigger sticks like gets caught on the handle wich then cause it not to stop

Word of advice : if you buy this do not buy cheap bits to go in the end of it. So much power it managed to snap one (hammer head end) and bend the other (socket reciver end ) neither supplied by Ingersoll rand but some Chinese company on Amazon (bent one was very hard to get out) If you’re looking for massive power and durable supplied bits this is what you’re after :)

Amazing too works effortlessly A++++++

Not used yet but looks good Quality

IR is my go to for everything pneumatic. This air hammer is a great tool. It's a little heavier than your standard short barrel air hammer obviously. It really packs a punch. It has a feathered trigger so no need for an airflow adjustment knob.All in all it's a great tool for a great price. TIP: BUY THE KIT OPTION AS ITS THE SAME PRICE AS THE TOOL ONLY OPTION!!!

Ottimo articolo.

Otroligt effektivt sätt att ta lös sådant som rostat fast.

アメリカからの取り寄せで心配でしたが無事届きました！因みにメイドイン台湾です！（笑） スナップオンのエアハンマーは高過ぎて手が出ませんが、こちらは半分以下でSK11より高級そうだったので購入しましたが大満足です！ とりあえず200リッターのドラム缶のフタを切断してみましたが最高に使いやすし、ガスで切断するよりも格段に素早くできました！ 次はアタッチメントを購入してタイロッドの取り外しや、壊れたベアリングの取り外し、等にも挑戦してみたいと思います！

Good price and fast postage