[10 Pack] UV Adhesive for UV Tempered Glass film,[Rapid solidification][Fingerprint Unlock compatible][Easy to remove] Loca UV Glue for all models of UV Screen Protector

First things first, hats off to the seller Ackoo. I wanted to know if I could use this product with a regular tempered glass screen protector that already had glue on it and they gave me plenty of warnings and notes.The product itself is excellent, has low viscosity almost like water, spreads easily and forms a perfect seal so you'll never have dust under the glass or double reflections.Prior to applying, I did a test with some clear plastic and UV cure lamp. The product cures to a softer firm consistency. I'm sure when the time comes, it'll be easy to take off.FYI I'm using this on a pixel 9 pro fold outer screen and I had to use a lot of stickers to seal the buttons, speaker grilles and mic holes.I also have a tpu screen protector on top of the glass screen protector because swiping on the keyboard is much smoother and reflections are handled better.

I have a rugged smart phone and I go through a screen protector once a month because the screen is curved. There are 2 lines that run the long sides, one on each side and are 3/16 wide. I tried oil but it evaporates and the screen protector still isn't contacted to the screen. I put this adhesive down the side and used a UV room sanitizer for 5 minutes. No line and it seem it's in contact. Time will tell.

Best if have done this at least once.

The glass on the front of my phone head broken and I had no glue, so this is a saver.

It never worked. I have a dead phone up to now.

Had no problems using this with a glass screen protector from eBay for an S22 ultra and an old UV light from an Amfilm kit. Used about 1.5 bottles and it cured within a minute. If you use too much or if the formulation is too thick it may never cure. Mine was just right (slightly watery but still a gel).

Little higher viscosity than what I originally used and it was much better. Did not run off so easily. Make sure to add weight to fingerprint reader and it will work pretty well.

Works as intended. Good viscosity, nice flowing thin fluid to get into tiny gaps with no trouble.Made it with a screw-on cap at the cut-once end to save the half-used syringe and I will give it 5 star!