H11 H9 H8 6000K HID Xenon Bulb x 1 Pair Bundle with 2 x 55W Platinum Digital Ballast (Diamond White)

Great quality and improved my headlights brightness like 10 fold. I bought them in November 2024 and so far they work perfect. HUGE improvement compared to my original H1 incandescent light bulbs and much better pattern and brightness than LED bulbs. I own a 2001 VW Beetle 1.8T which has the factory projector lens headlights. This is very important because the LEDs don't work well with projector lenses. the HID ones have a full spectrum and ominidirectional light that the lens can focus and create a bright, clean beam, compared to the scattered and spotty ones using LED light bulbs. Highly suggest to have these installed professionally. I used two 30 amp relays (one per ballast) connected to the battery (with a fuse of course) and two fresh grounds to have a solid connection.The old 12v original power from the switch is now used to trigger the relays and bring clean, powerful energy to the ballasts. Everything has been performing great and my headlights work absolutely great, have great visibility at night and have a nice clean, beam with a cutoff to not blind oncoming traffic. Highly recommended!

Started off great for 2 months. Great lighting provided - until they stopped working. It was clearly some connection issues with the wiring. Good for the short term, but don’t bother because you’ll swap over back to halogen in a few months.

Worked great in my 2013 WRX, until it didn't. I had a bulb go out and I emailed the company, they responded same-day offering to send a replacement, originally we thought the ballast went out but after receiving the replacement ballast and discovering it was the bulb, they send a new pair of replacement bulbs no questions asked. The bulbs are bright without being massively overkill, having a couple vehicles with HID's these match OEM performance without being "that guy" on the road blinding oncoming drivers. If you have a projector vehicle with factory halogens, this is an excellent upgrade to modernize your headlights without needing to replace Amazon quality LED's that inevitably die every 6 months. (Do not use HID's and LED's in reflective housings, they'll upward cast into drivers eyes, and give you less visibility bad weather like rain, fog, and snow, stick to over bright halogens if you need a bit of extra lighting for reflective headlights. Bad beam patterns are worse than insufficient light!) The 6000K is a little bit more on the blue side than I expected, giving a bit of that hospital room fluorescent green to everything, I'd highly recommend leaning toward 5000k if you're looking for a more pure white/OEM look, but only 6000k had 2 day shipping when I ordered. The HID's only take around 10 seconds to heat up and hit around 90% brightness, the other 10% comes through over the next minute or so, similar to a CFL bulb. I highly recommend these as a simple bolt in upgrade for projector headlights, I'd keep expectations in line with the price tag but it's good to know the seller backs their warranty.

These HID bulbs are bright, easy to install, and offers excellent value. They fit well in the housing and appears to be of good quality.

***update - installed the bi-xenon projectors and it really improved the light output by a lot, these lights are very bright. I had to drop to 4-stars because my left ballast went out after, I'd estimate 3 hours of use. After the car sat overnight, the ballast started working the following night. I've only found it did this one time so far, but I suspect this will be an ongoing problem. I'll keep an eye on it and if it does it again, I'll see what Innovited does for a replacement and go from there. (2010 Honda Insight, keep in mind, my OEM headlight projector housing buckets are very deteriorated, it's very dangerous to drive at night with how little light the headlights were producing) So far, so good after a week. I'll update the reviews once I get everything completely installed and tested properly. The 5000k is not pure white, however my headlight reflector has one side which is lined with a blue reflector, so that is likely causing the slight blue hue. I did a lot of research and found that OEM headlights using projector buckets mounted inside, the reflective aluminum coating will sometimes deteriorate and prevent the light from reflecting and projecting properly. I knew this would likely be the case for my car, so I wanted to give the HID's a try first to see if any improvement, and order a set of universal bi-xenon projector lenses later, if needed. Just switching to the HID's alone were about a 20% brightness improvement over the basic Sylvania bulbs. A very noticeable improvement, but not quite to where I'd call it good. Quite a bit of equipment and wiring needing installed though for only 20% improvement, IMO. Installation was rather easy though, and it was direct plug n' play. I ordered some cheap aftermarket bi-xenon 2.5" projector lenses not realizing they only accept H1 bulbs (also H4 & H7 with supplied adapters), my H11 bulbs would not work. I went ahead and ordered two Innovited H1 5000k bulbs. I've tested these bulbs and projectors outside of the headlight housing and can confirm, they are super bright. In order to open the headlights to make the projector swap, they need to bake (or heat gun) to loosen the adhesive, so I'll be doing this over the weekend when I have more time. It's going to be nice to see at night again.

Changed my 2016 Tundra to HID lights with a cheep set of projector lamps (also purchased here on Amazon) to HID and gained a lot of safety driving at night. I have used Innovited HID lamps now twice on older trucks to get some visibility...last time on a 2014 Ram EcoDiesel, they were in place and going strong after 2 years....didn't hesitate to get them again this time.

One ballast was dead on arrival. The working one looks good

Entrega a tiempo. Las luces se ven bien.

كويس لا بس

Éclair très bien. Mais j’ai dù installer un relais pour les contrôler. Ça fait maintenant 3mois et tout va bien.

These Hids were quite eventful! Installed in my 2012 ford fusion the light output was great! The cutoff was sick! Come the problems! I’m running switchback led drl and that’s a big no no for hid low beams. If I did not have the auxito switchback drls the would work but I do and they don’t! Ended up returning. ALSO it fried my noco maintainer.