Fisher & Paykel 420094USP Washer Motor Controller 120V

This worked perfectly on my 20-year old washing machine.

Simple to install if you keep track of the various cables and tubing and where they go. Worth buying OEM new instead of used part.

I installed the controller, set it to the size of my machine, it works for a while then stops at the rinse cycle and has to be restarted 3 times to finish the cycle.When tested for default codes, it has none.I would like to replace it

I didn't look close enough, and I accidentally bought this 420094USP. But, I needed 420094. I didn't realize those were two different parts/part numbers.This is a 420094USP. Make sure that's what you need before buying.

Careful who you buy from. I thought I would save some money and purchased from one of the Used in good condition sellers. Upon receiving it I opened it up to inspect the board. The soldered glass fuse was already blown and looked to be already replaced once before judging by the poor solder joints. This is a known issue with these washing machines, drain pump gets wet and not only fries the motor but also the control board. Reason I am replacing mine. New pump has inline fuse to stop this issue from happening. I'm guessing many of these used boards are ones that already got fried.

Waiting satisfaction on picture part not what arrived from Pandora's OEM. At that time I will have a raving review or a scalding criticism. I am into determing problem wiht washing machine for two weeks and recently got expert help on finding problem. I immediately ordered what I understood to be identical to part pictured, paying expedited freight to only find out when it arrived it is not the part pictured that was representing ordered part.

So far it has not failed again. The last issue turned out to be a faulty rotor sensor. I noticed the rotor sensor clearcoat over the printed circuit board was insufficient for the moist environment. Make sure that isn't the issue before buying the control board.

This 420094UPS is not a replacement part for the 420094 Motor controller. To use one would have to rewire the connections for the Pump/Motor connection. The GND is not identified as it is on the original. The Diverter connection has fewer pins than the original. Returning.