Abbey Hardware Fence Panel Clips - 44mm & 50mm (10, 44mm)

Ideal fence panel clips to mend your fences if they suffer storm damage.

Delivered in fast time. Bought to install secure new fences and in the main stabilise stop being stolen,rattling in wind, bit wider but easily fitted as was able to bring down sides in place. Bend for the price get what you pay for and less expensive. If anything you don't mind as long the fences are in place okay, good deal for price works for me.

Hold fencers

I alway use this type of clip for my fences. I ahve put up 40 fences it total.

Bought these rather than the make I had previously purchased on Amazon recently because there was next day delivery whereas the previous purchase would have taken circa 5 days and I needed to finish mounting numerous pieces of trellis etc. Should have looked at the pictures more closely as it is clear these are about half as thick as the others I bought, you can quite easily bend them by hand - not much thicker than a tin can. Time will tell if they do the job as well but I am dubious....Update on these, not fit for purpose, tried to fit an 1800 x 200 in trellis in the horizontal to the top of a fence panel and simply not strong enough to hold upright. First strong wind will bring them down. May be o.k. If fitting in the vertical with only a very light load but can't handle this job. As two have already distorted I cannot return them but will look for something more robust...

Fantastic product. Used to secure wooden fence.Worked a treat. Thankyou

These are good clips. You can bend them back to slot in the panel and then rebend to finish, so you don't have to lift the panel vertically into the clips. Some other clips are thicker, which is OK, but makes bending them a lot more difficult. They are still strong enough to hold the panel properly in place and of course it is much easier to remove the panel in future to change it, rather than sawing through the rusty nails that attach the panel to the post if you don't use clips. I would supply them pre-bent, but it's easy enough just to bend them temporarily back to insert the panel. They can accommodate quite a range of sizes as they close up when you drive in the screw.Because they are bare metal they stick out a bit visually when looking at the panel, so generally best if you intend to paint the panel.

These did the job but they are very thin compared to the ones I bought in my local supplier. Unfortunatly they did'nt have enough for my needs so I ordered these, they allowed me to complete the job but as I said they are about half the thickness.