Bike Computer with Wireless Heart Rate Monitor Speed Cadence Sensor 38-funtion Bike Speedometer Odometer Backlight Altimeter (DCY438)

This is my first bicycle computer so I cannot compare it, but I like it very much for what it does. To have bicycle speed,average speed,odometer,trip meter,temperature and time on display is a benefit to cycling. All that for the price is good value. It does take a bit of time to figure out how it works. Install was straightforward. After install I was curious as to the accuracy of the device. As I found out,this all depends on the number you enter for your tire circumference in millimeters. Initially I used the included chart. Where I ride there are milage markers and mine was off about 50 ft per mile. This was too much for me. I rode 7 miles with a 350 foot error. Here is how I fixed it to bring the accuracy within the resolution of the device which is approx. 5 ft/mile. Find a flat surface and lay a tape measure down for 25 feet or so. Using a piece of chalk mark the tire and the surface you are rolling on as zero. Then carefully count the rotations of the tire,I did 3. Take that liner measurement along the ground surface and divide it by the number of rotations to get your actual circumference of your tire. The more rotations and longer the distance the more accurate you will be. If you measured in inches, then convert it to millimeters. Round it to the nearest whole number and enter this into the device. This worked great for me.

Works great to track distance and speed. Regularly use this on bike rides to track how far I've gone, average/max speed. I used this in conjunction with my phone GPS and it's fairly consistent.

I bought an ebike early in 2023 that came with a very simple controller, no display. I absolutely love this meter. I use it on SCAN so I can see Trip miles, Trip time, Avg Speed and Max Speed scrolling at about 2 sec intervals. I bought another ebike for $200 more than a new battery and motor would have cost for the old one. I still ride the old one for a few reasons, so I don't want to remove the meter. The new bike came with a large display, but no scan function, and seeing top speed and average speed is a real pain in the neck. It takes me 3 tries to reset the trip meter. This one's a no brainer. The older bike has ~3,000 miles on it, and it and the meter are on their 3rd year. I have had no issues at all with this meter. As far as battery life it lasted 2 full years. It's a simple install, and if you really want to be completely accurate there are instructions on how to measure tire travel and set it precisely. For my use I just entered the circumference of the wheel in centimeters, and according to my car it's spot on. One nice function is temperature, although it seems a bit "ambitious" as it's usually 1.5 degrees higher. No biggie. Connecting it to the bike is easy, and since it's wired it doesn't drop out like a couple of wireless models I've tried. I did manage to lose the magnet, but bought 2 all metal magnets for $8 and there were no issues. I wanted to get one for a non-ebike i bought last year, but they were sold out so I put another that was double the price i bought originally on it. It also has a scan function, but is less informative and harder to read. I was very happy to see they are back in stock. For such a good price it's a really good meter and accurate. One note on changing the battery: write down the ODO mileage, since when you remove the battery there's no "hold up" function and you have to re-enter total mileage. It's noted in the instructions, and it's not a big deal. Oh, and it also displays an icon of a wrench to let you know it's time to oil the chain and tighten the spokes. There is also an Up and Down arrow to let you know if you're above or below your average speed. All of this for a very reasonable price.

This was sold as a new product but was previously sold and returned. When I received it 4 batteries were already installed and 2 more were in the package. I replaced the 4 installed batteries with new ones and installed the computer and both sensors and put on the HRM. After going through the setup procedure (e.g. clock, wheel size, etc.) I rotated the crank while my bike was on the bike stand. Everything seemed to work perfectly except the B button changed modes (bike, altimeter, cadence, HRM) and the A button scrolled through options in that mode. This was opposite what was shown in the instructions but not a big deal. Then I touched the rear brake to stop the wheel, and I noticed the computer reset itself. I went through the setup procedure again and turned the wheel. Again everything seemed to work perfectly, but the computer eventually reset itself. I went through the setup procedure again with the same result. My conclusion by now was that I had a defective computer. I suspect this was why the computer was previously returned (remember the 4 installed barrettes). I did not try to contact the seller for two reasons. First, they did not believe the previous purchaser or they would not have resold the defective computer. Thus, there is no reason to think they would believe me. Second, this was sold as a new computer. It was not! I returned the computer (thanks Amazon) and ordered a different one with a better rating. BUYER BEWARE!

Ließ sich problemlos anbringen. Faltrad 22 Zoll. Es lassen sich fast zu viele Daten abrufen.

Great little computer for kids bikes,

I run this speedometer from the rear wheel of my bike on a turbo so that I can cycle indoors because of bad weather and the covid lockdown. The unit was fine for the first couple of weeks but then ceased to register speed after 20-30 minutes of exercise, and then shut down completely. The unit itself and its battery are fine, but the problem lies in the leaf-switch, which seems to become magnetized after 20-30 minutes of constant pedalling. This closes the switch's blades, and so no signal can reach the unit. The problem resolves itself after a rest, but that's of no use to me, as I want to monitor my exercise for an hour at a time. I have fixed matters by getting a better magnetic switch from Amazon that I've wired to an old cable from the shed. However, the speedometer assembly that's sold (handlebar unit + switch) was not fit for my purpose. I could have saved money in the first place by buying a similar speedo from our local Home Bargains for £3!

My first was faulty and the seller was very kind and gave me a second delivery at no extra cost. 5* customer service! The speedometer itself is slick. Standard left button to freeze recording and right to cycle through menus. It even has a thermometer! Only grievance is there is no backlight, which would be nice. Other than that, it's a quality piece and easy to install and remove when locking up my bike.

💩💩💩💩