Thermal Pad, 100x100x0.5mm Highly Efficient Thermal Conductivity 12 W/mK, Insulated Heat Resistant High Temperature Resistant Silicone Thermal Pad for IC SSD CPU GPU Heat Sink LED Cooling

Got this for my new Onewheel controller. Hasn't hit 100F since installing it. Seemed a lot more quality product compared to the thinner stock one I was replacing. Easy to cut to fit, and work with in general.

Update:Finally put it to use and it worked as expected. Glass bed held in place on top of the stock bed with this alone—no clips needed. It definitely adds some height (and weight) to the bed, reducing the height you can print. I never printed fast enough for the weight to be a issue. Cleanup was from the glass was easy, so not removing it was never an issue.I eventually went back to the stock bed as materials like to stick to the BuildTak type surface a lot easier and leveling begged for an auto leveler setup. Removal was easy and it slipped back into the original packaging, but a couples corners bent so reusing may require some trimming or some squishing.Speaking of squishing, be careful on initial install to not put too much pressure any one side or bed leveling may not work out as desired.1mm thick may have sufficed for my purposes.Original:Giving five stars based on it coming as expected and well packaged. Though full disclosure as I have not put it to use yet.I bought this to help adhere a borosilicate glass plate to the bed of an Wanhoa i3 Plus (Monoprice branded.) The fit is perfect, and I have high hopes about the thermal transfer to the glass plate.Problem is I am debating losing the simplicity of a removable bed for easy part removal or cleanup, and so I am not totally tied to the idea any longer.That said I still plan to try it out as I’m suspecting thermal transfer may improve or at least the heat be more evenly distributed.I’ll update my review after I confirm.

Multitude of uses for my repair bench. Good quality, heat transfer, and thickness.

Old 1070 was having thermal issue when playing BL3. Made a big thermalpad fill so the board contacted the backplate through the pad. Also replaced VRM and VRAM thermal pads along the way in the front.The thermal pad came through the mail and there was a big fold mark on the protective films, the pad sandwiched between was unaffected. There were ~1-2mm silicon chipped off near the edge probably due to shipping and handling. Both could be avoided if the pad was shipped with a cardboard inserted and used do-not-bend stickers.

I bought this to mount a heatsink on my GPU's backplate to aid with VRAM high temperatures.Pros:- Comes at a fraction of a price compared to reputable brands.- Easy to reapply without leaving a mess. I had to readjust the location of the strips a few times and never had trouble removing and reapplying them.- Brought VRAM temperatures down 10 deg Celsius, so it works.Cons:- I think it has higher hardness than Gelid Ultimate. Meaning, you will have hard time applying this thermal paste on uneven surface such as applying a single strip spanning multiple SMD components of various heights. In my case, the GPU backplate had a slight bulging and this thermal pad did not help at all to compensate with this. As a workaround, I cut the pad into separate strips, and try to carefully push against some to force them to make contact with both surfaces.Overall, it works very well with even surfaces. It's an affordable solution if you need a large quantity for even surfaces.If you plan to use this for a GPU backplate, remember that a heatsink with thermal pad is not enough. You need a fan as well to aid in cooling.

miner was overheating. took it apart and used this to replace the cracked thermal pads. worked very well and reduced temps significantly

Great seller, good product, great price!

Half is applied to macbook pro 2018 i9 intel. Bottom plate became very hot then mStand too. Then air cooled. Very satisfied