UCP205-16 Pillow Block Bearing 1 inch Shaft Pack of 2 Mounted Bearings p205 Cast Iron with 1" Bore, Self Alignment

Great mounts so far. They have been strong enough for my belt squat attachment. Holds 350lbs with no issue

These are exactly what I needed for my project. I was surprised I had to install the oil plug and yellow cap manually, but it's ok. Not sure what oil to use, or how I would fill these up, but I'll research that at some point.

Purchased these bearings to upgrade my lawn roller. To acutally use them I had to remove material from the center shaft (measured .9992" with a micrometer). I spent approx 15 - 20 mins on each side of the lawn roller with emery cloth to provide clearance to make these bearings fit. When finished, the axle measured .9844 and .9841. The bearings were bumped on with a brass hammer although even with the axle measurement less than 1.00 inch it did take a few good whacks to seat them on the axle. I did not tighten the mounting bolts very much because of the hollow area around the mounting tab in the cast housing for fear of breaking the housing. The bearings are working on the lawn roller and should provide adequate strength to provide long life with proper lubrication. I would have given a much high score if these bearings would have provided a true 1.00" bore and thicker cast iron mounting housing.

My friend needed these for his sprayer so I ordered them for him he said they work great

I put these bearings through alot. Keep them greased and they last a while.