CLZYLRS Resin Watch Band Mold Compatible with Apple Watch,epoxy Resin Personalized Watch Band DIY Silicone Resin Mould,iWatch Bands 38mm/40mm,Compatible for iWatch SE Series 6 5 4 3 2 1(M/L)

The watch band mold is perfect. It was my first time trying this and it came out great. It comes with enough pieces for one band, but if you can find the metal pieces elsewhere you can use the mold repeatedly. I bought a S/M for a 38mm Apple Watch and it fit easily.Some tips because the instructions are vague:- Use the side of the mold where you can pour the resin over the tiny metal bars.-Pour the band section until filled, and wipe it clean on the edges so the band comes out neat. Fill the two holes up until it is the same height as the center rectangle. Wipe the rectangle clean.- Put something over it while it dries so dust does not accumulate. Occasionally for the first few hours, I would check on the band to wipe the edges that spilled over.- Maybe half way through the drying time, when it is soft but not liquid-like, gently pull out the three metal bars. I was worried they would be stuck if it dried completely.Once it’s dry:- Remove all the parts from the mold. You can use a sharp knife over a cutting board to cut the rough edges, if any.- The clasp: The small nib must be inserted after you have the bar through the first hole.- The links to the watch: Use the small tool with a tiny fork like end to push the clasps into the hole, one by one. This takes a second to get a hang of.The loop that holds the extra band part was scratchy against the wrist so I removed it.This band is a little wide for a thinner wrist, but is perfect for my brother. Hope this helped! ❤️

The resin stuck to the edges and ripped the silicone out the first time I used it