Type K Pipe Clamp Temperature Lead Probe HVAC Pipes Jaw Clip Plumbing Clamp

Works decently. Pretty tight closing pressure. Seems slightly on the cheap end, but if your not using it a lot I am sure it will last a little while. Not sure how it would hold up to daily use for work of some sort. I only need it occasionally. Fine for my needs.

Works as expected

I use this pipe sensor for Refrigeration mostly, so far has been working fine, quality might be a little less than excellent but so far is holding up. For the price I think Is a good purchase

I compare this clamp to a fluke clamp I bought for $200 it was within .2 degrees Fahrenheit

Wire off clamp is very short and already show signs of failure

I'll see how can I make it work. Plastic material seems more strong than SMAN, spring is less force that also better than SMAN whose spring too strong body broken. I'll update after I calibrate it.I reduced from two to one star, will update if I got the replace to work. The reason is the ohm of the said K probe measured 4.3ohm, while original SMAN3 is 14.3ohm and HT206D multimeter's probe is 14.5ohm.I confirmed the clamp I received cannot be used for SMAN3, HT206D and Fluke 85, and believe Fluke needs to use its own probe, I don't know why, by principle all measurements shall measure uV-mV.Update: after I sent back both, wait for 40+ days to get the refund. The normal refund is 1day.Now six months passed I still have not received my refund!

Great tool.

The clamp I received was inaccurate and readings were not consistent.