Akocire 18V 20V 4.0Ah 5.0Ah 10-Cell 18650 Battery Case Parts Cover Replacement for Dewalt DCB200, DCB201, DCB203, DCB204, DCB205 Battery Repair DIY Kit(No Battery Cell Included)

Good shell, worked as intended

Needed a little mod in the button but other than that it is a great full rebuild kit. I even swapped my stickers in. Glad to have my battery back. My battery shell had cracked and had lost the spring.

Great kit easy to do. People out there you will need a spot welder to weld these batteries together. See pic of the one I made from a kit here on Amazon .

all the parts are there, but this circuit board will not charge on a charger. The diagram shows a board labeled 16v-blue wire 8v-green wire 4v-yellow wire 12v-grey wire my board is labeled B4-green B2-blue B1-yellow B3-white Using the pic on the ad, B1=4v B2=8v B3=12v B4=16v However this does not work as I get no response from the charger and it works with my other batteries. Reviews indicate these are notorious for not charging, I guess I should have stayed away as I now have 10 very expensive 18650 cells that i cant recharge in this case PIC SHOWS A AMAZON BATTERY ON THE RIGHT SIDE OF A NEW AMAZON DOUBLE CHARGER [BLINKING] AND THE "KIT" BATTERY ON THE LEFT SIDE WITH NO LIGHT RESPONSE AT ALL. IF I USE MY DEWALT OEM SINGLE CHARGER IT TURNS RED THEN THE LIGHT ALSO GOES OUT **UPDATE** I HAD FULLY CHARGED AND BALANCED THE 10 CELLS, AND SO AFTER VERIFYING THE BMS WIRES WERE INDEED CORRECT, I USED THE BATTERY TO DRAIN IT A BIT, THEN UPON PLACING IN EITHER OF MY CHARGERS IT DOES ACTIVATE THE CHARGING CIRCUIT. I ASSUME IT WAS JUST SO FULL CHARGED AT BUILD THAT IT WOULD NOT ACTIVATE THE CHARGING CIRCUIT.

I bought this to replace the case on a genuine 5ah dewalt battery, so I didn't use the cell holder, contacts or zinc strips. The original cell case dropped right in, but I did have to solder the supplied battery indicator on it since it uses a different button. Its clicks right in on the tools and charger. My only complaint is that the orange sticker on the battery indicator wont stay on, i will probably have to glue it in place or leave it off.

I just needed the case & it worked out great

I bought 2 kits, one didn’t come with screws but everything else worked okay.

works good easy to replace

cheap plastic, lasted for couple of days before breaking apart