YUFANYA 2.5 Inch Bi LED Projector Lens with Hi/Lo Beam,70W 20,000LM 6000K White,Sliver Shrouds Mask,Fit H4 H7 9005 HB3 9006 HB4 Car Motorcycle Headlight Retrofit

Decent out put , if space are tight go with this …

These worked fantastic to replace a HID kit in my 2003 e46 BMW 325Ci. Very straightforward installation and wiring, and I like that the shrouds screw onto the projector housing instead of having to use double-sided tape or just clipping on. The projector cutoff is straight, and the brightness is very good. My new go-to projector setup for project cars! No problems in the couple of weeks I've had them installed.

Installation was simple using the provided fittings, and the clarity and light output are impressive. I installed them on a set of headlights for an Expedition, and they both look and perform great. Definitely a good value for the money!

If you want to improve your night driving fast and affordable this is the way to go, others may be better but more expensive and harder to install, the only hard part with this is removing the plastic covers of the headlamp. Im happy with the performance so far.

Received these as a Christmas gift (got to pick what I got) got brand new housings eager to do a retrofit. Well first off when I originally installed onto my truck the headlights were about 4-5’ off of the ground (about 5 feet away from garage door) with my adjuster turned as far out as it would go hoping to bring the headlights down. Was un-drivable (blinding oncoming cars and just focused way too far ahead that it was basically like I had no headlights on unless I wanted to look at the tops of trees) figured it was an installation mistake so I removed headlights and flipped projectors 180 degrees. Now I have the opposite problem with headlight adjustment screw max in light isn’t far enough ahead and headlight has the hard line up at the top. I have no complaints with the highbeams but for obvious reasons I can’t just drive around with the highbeams

Put these in my 06 Audi A3 halogen oem headlights. Very impressed with them so far! Cutoff is sharp, very bright, white light. And it did not trigger any light error. Been using them for 3 months now, time will tell how long they last. The threaded peg that fits through most headlight bulb holes makes it really easy and quick to install. I will definitely be using these again in future retrofits.

Relatively easy install, as far as building your own headlights go. I wish the projectors had markings to allow you to orient the projector upright during install into the headlight fixture such that the light cut-off will be level (flat). There isn't an easy way to know the orientation from the rear when you're making adjustments, unless they're installed in the car and turned on. I had to make adjustments after installation which was a little difficult because my engine bay is very cramped.I ordered an older version that came with "BMW Halo Eyes" that's no longer available to order. One of the halo eyes did not work out of the box. Other than that, they are functioning well in low temperatures. I will update my review after some longer road trips I have coming up.

2006 dodge sprinter, you will need to remove the shield by wiggling it out and then use a router bit on a dremel to cut the plastic back flush so the light assembly sits straight in the assembly. I also drilled a hole through it to get the high beam wire to the back. Used 14/16 connectors for the wires