3650 Vibration Motor- DC 12V/24V Motor 3800RPM Big Power Electric Massage Bed Industry Vibrator Sieve Vibration Motor 10W (12V Motor)

This will change your naps into true “power naps “.

The 24 volt oddly enough is weaker than the 12 volt. I wouldn't have thought that however the 24 will not do what I need it to do. But the 12 volt does it's a good product. The only complaint is that they only credit you the money after they receive it which is up to two weeks after you send it. (correction) the vendor changed that yo ,30 after they recieve it. by far the worst return policy I've seen on Amazon)

In the old days, when traveling Route 66, every motel had a vibrating bed. For a quarter, it would put me to sleep instantly. Had I known it was such an inexpensive setup, I would have done it long ago. I read this helps the lymph system get rid of toxins.

I bought this vibrating motor for my bed. I attached it to a 1x6" board and slid it between the box springs and mattress. I let the motor hang out along side the mattress. Pinned the controller to the mattress cover so I can adjust the speed. My bedroom has an outlet that has a light switch that controls that outlet. I replaced the switch with a timer and connected the vibrator motor controller to that outlet. Now, I can set the time anywhere from 5/15/30/1hr/2hr/4hr and it will turn off on its own. You can buy the timer at walmart or here on amazon or any big box hardware store for about $20. I tried connecting the motor underneath the box springs, but the rattling was terrible. Attaching it on a board and slide it between the springs and mattress is the best. I barely have the motor speed on at all. Don't need it turned on more than 11 o'clock. We'll see how long the motor last.. Very relaxing

Installed in an Eastwood bench top sand blast cabinet. Put it on the back of the funneled part of the cabinet. Keeps media rolling down to the suction. Put fender washers and nyloc nuts to keep it put.

The media could not be loaded. when I increase the motor speed it stops working

We attached this to a spring-leg table for curing molten chocolate and small epoxy molds. It worked great and for a great price!

Works well, very strong and good product.