Philips LED InstantFit 2-Foot T8 Tube Light Bulb 1050-Lumen, 3000-Kelvin, 7-Watt (17-Watt Equivalent), Medium Bi-Pin G13 Base, Soft White, 10-Pack

I thought I could install these in the 50+ year old fixtures because the current tubes specifications suggested it would work. It takes a little research but I found from Grainger: Centium™, Electronic, Fluorescent Ballast, Ballast Start Type Instant, Item #2MCX5, mfr. Model #ICN-2P32-N. There is an unintended consequence, my wife likes to listen to the radio while cooking. The radio is hard wired above the recessed lighting above the kitchen sink counter. The static is so loud you can not listen to the radio. I have not had time to figure this one out yet.

Arrived fairly quickly. Pretty easy to install even though I had to rewire my fixture. It was the old t12 with magnetic ballast. No one stocks 3ft led bulbs locally so I’m pretty satisfied. Only downside is I had to buy a case. Only been installed for two months now, so I can’t comment on longevity. The light output is very bright though.

Bright daylight colored light. Lights up instantly and was plug-and-play in my electronic ballast. The LEDs look way better than fluorescents.

These tube lights appear to be a mechanical fit, but do not work in a common household light fixture shown in the attached picture. The house was built 2016-2017, so the fixture is not very old.The light turns on for 20 seconds, subtly flickers for the last 5 seconds, then turns off. For a few minutes after, the light does not turn on at all. After several minutes, the light turns on again, stays on for 20 seconds, starts to flicker, and turns off.I tried two of these - they both exhibit the same behavior with this fixture. It seems to be a compatibility problem and I see no way of knowing that it won't work in advance.

Brighter than I thought they would be. Works fine in my ballasted fixtures. I wouldn't call these warm. They are white and seemed whiter than 4000K but that is what I prefer.

This is the perfect solution for converting fluorescent lighting to LED without having to bypass the ballast or replace the entire fixture. I just installed them and hope to live long enough to see if they’re good for 50,000 hours.

Love them. No rewiring. Install like normal bulbs. Great price. This is the one you are looking for.

I have been repairing multiple over bed lights and these provide excellent light. The only downside is that I also had to replace the ballasts as they were incompatible.