Tinksky Stainless Steel 0.3mm Needle Replacement for Airbrush Gun, Pack of 5

I got a "Lightwish" brand airbrush kit about a month ago and have been enjoying airbrushing. A couple of weeks ago though, I got tired of the airbrush. It would clog so badly that nothing would flow out of the nozzle, both air and paint would backflow into the cup. I ordered a Sparmax SP-35 airbrush (which is awesome and works great) just to replace the Lightwish one, but after a bit of YouTube cruising, learned that replacing the needle might help the Lightwish airbrush. So I ordered these.That did the trick! Swapping one of these needles into the Lightwish airbrush fixed it's flow issue. I've been using that airbrush for nearly two weeks now and the airbrush hasn't clogged once. These needles are visibly better quality than the needle that was in the Lightwish Airbrush. I wanted to take a photo but my phone camera couldn't capture the difference in quality between the Lightwish's stock needle and the needle from this pack that I replaced it with.So, now I have two functioning airbrushes. I could've saved money but just getting this needle pack and not getting my Sparmax airbrush, but I'm quite fond of the Sparmax and am keeping it. But with one of the needles from this pack in the Lightwish, it works perfectly fine so I have no qualms about using it as well.If you're having clogging or flow issues with your airbrush, then a new needle may be what's needed to fix it.

They’re pretty straight forward, easy to clean and install into an airbrush. They work pretty well in the airbrush and helped give some pretty good coverage.

Great buy for the cost

I use these for art detail work, and these are pretty durable.

After bending a couple of needles I was looking for a cheap solution for a cheap airbrush problem.These needles are, in my amateur airbrusher opinion, a great replacement for the original needle.I would not use these is my other airbrushes but for a G22 they are great

These have a slightly smaller circumference than the 0.3mm I was replacing. I'm new so I wasn't sure how much it would matter. Seemed to work decently at first, despite oddly not able to do a full spray while also not spraying paint at the front position (when it should only be air) - so I had to choose which was most important.I used backflow to mix the cup, but that apparently was enough to send paint all the way through my brush (which I figure is a result of the diameter not creating a full seal). So I had to totally disassemble and clean my brush after using this. Not a good needle, necessity ONLY.

Although you can get away with a few sprays or a very small job, these are just slightly smaller, so the needle sticks out a bit farther, and the O-ring does not make a good seal, so it leaks down the trigger, making a mess. You also have to crank down on the nut to make it secure. Not recommended for Grex I guess.

These were packaged very well and fit great into the YN airbrush for nail art.