IRWIN10505162 14TPI Pullsaw for General Carpentry, 300mm

It’s so easy to use, cuts accurately and the finished edge, on any thickness of wood, looks like you’ve used a knife.This is my 4th saw, it’s a must have

I've lost track of how many of these saws I've had, since they were sold in B&Q under the Shark brand. I have the 300mm, the tenon saw and the little one. They are great for everything from rough fencing work to finish carpentry. They cut quickly with a very fine kerf. They are also great for cutting work surfaces and laminate, although this will trash the blade, hence why I'm buying another.The blades are removable, but unlike the previous brand, Shark, Irwin do not sell the blades separately, which is a shame, and rather wasteful.

Good quality saw was going out would be good for flush cuts but it's not as it still marks the material. Everything else is great

I needed to saw a worktop in the kitchen so I could fit a fridge freezer. Using a normal saw will chip the worktop so I looked around for a saw that would give a fine cut and hopefully not cause any chipping. The Pullsaw seemed to be the answer so I bought one with 14TPI and this did the job very well. I went for the 14TPI and not something finer because I wanted to use the saw for other more general jobs after the worktop job. I had never seen or heard of a Pullsaw before which is a shame because it is such a pleasure to use and cuts beautifully. I recommend a Pullsaw for any DIY person.

This tool is great it takes the stress and strain out of sawing as no effort is required to use it as it cuts when you pull it back opposed to other saws which cut when you push them, thus requiring effort. this saws predecessor is used regularly but alas is getting a bit long in the tooth at nine years old and is not quite as sharp as it used to be, I once tried to sharpen a saw and failed therefore it is easier to buy a new one. The pullsaw also cuts very cleanly and does not chip the edges, I would definitely recommend buying one all saws should be like this.

I used it to cut an MDF panel of my kitchen and I admit the result was far more impressive than I expected, even though I used pull saws before.The cut was neat and clean with no apparent chipping of the colour coating layer.

I bought this as i needed a replacement blade for a 'Sharksaw' and although i trawled the 'net for a replacement blade to no avail, the blade of this item looked very much the same. It was cheaper to buy the Irwin saw with a handle than get a replacement blade(!?). The blade does also fit a 'Sharksaw' handle. The pull saw is brilliant, very smooth cut and needing very little effort. It's a lot thinner than regular saws as it only cuts in tension and not compression so its a great saw to keep in my smaller toolbox.

I have used a few of these saws over the years and they are very sharp and nice to use. The only issue with them is that the handle can be detached from the blade (by pressing a button), but replacement blades are not available in this country.

Cumple todas las expectativas. Lo recomiendo. Conozco la marca Irwin de mucho tiempo y fuy y soy contento con todos los productos que he comprado de esta marca.

Ottimo prodotto come tutti i prodotti Irwin che ho acquistato.

O facto de separar pega da serra torna se muito útil para arrumar numa caixa de dimensões médias