Brccee AC10pcs FR PVC Cover Flame Retardant Sleeve for ANDERSON Powerpole Connector Housing

These work well with my ANDERSON Powerpole Connectors.

I debated for a while about these, my only hesitation was the comments of extended delivery times. So when I finally decided to order, I ordered two packages. Received them this morning and just finished a fuse link setup with them. WISH I'd ordered four packs!!!Although though they only offer a small amount of stress relief, they do give some and offer a lot of dust/dirt protection on the back side and just give the cables a very nice "finished off" appearance. Not to mention, they cover the sea coral sharp edges of my PowerPole edges and corners.My first application was on 12awg zip cord so I just barely trimmed a bit from the closed end and ended up with a very nice snug fit. I don't foresee a problem with 10ga but larger may be mighty tight. I think if I ever have the desire to use these on anything smaller than say 14awg, I think I'll use a leather hole punch to cut a nice small hole and using a round wood dowel that fits up inside the boot as the anvil for the punch.As far as the shipping goes, I received mine within a week and during the C O V I D - nineteen crisis.I would definitely (probably on my next Amazon order) order again and could recommend without hesitation.

For what they are they work alright. I thought these were hear-shrink to really give it a nice tight finished look. They are not. As for a cover it fits a little loose but better than nothing.

This is my second time purchasing these boot covers for Anderson Pole connectors. I went back and added them to all my cables and connections that I have made in the past. There is no hole on the end, so you have to make your own. I usually drill a hole through the end, using a drill bit that is just a bit under the size of diameter of the wire that I intend to use. If the drilled hole is a bit to small when I try to poke the wire through it, I carefully cleanup the hole using very pointy wire cutters until the opening is large enough to allow the wires to go through it. Patience at this point will result in a very nice, clean looking installation once the boot cover is in place. The first time that I ordered these it seemed like it took forever, but with this last order they came the following day. So I am that much happier.

Didn’t know the device I was buying them for came with them too. But I can use them for other projects so I’m happy .