JDMSPEED 2 inch Triple Gauge Set - Oil Pressure, Water Temp, Volt Meter (Oil: 0-100 PSI, Water: 100-280F, Volt: 8-16V) - Fits GM, Ford, Mopar & More

Works! Looks great in old truck!

Reliable

The oil pressure gauge in this set is not designed to use 1/8" copper tubing. I never use plastic tubing. Copper uses compression fittings and the copper tubing will not fit inside the gauge end without taking a chance on drilling it slightly. Rather than that I purchased a sunpro oil gauge that accepts the 1/8" line and compression fitting. So the oil gauge is useless unless you don't mind using plastic tubing.

Put it in a s10 it was cheap for the great quality of a product I got! I highly recommend it! The gauges in my old s10 weren't working and this helped so much

Awful quality gauges . Not one was usable … the water temp sender is way too large to fit in any intake / t that I know of ( way larger than 1/2”npt ) . The oil pressure gauge plastic line linked and destroyed itself the first time I tried to install. The volt meter bracket hits the terminal for the positive which would cause a short . Not one usable gauge . Wish I opened the box sooner so I could send this garbage back and get my money back

Came as pictured, easy to install on my 83 el camino

Works as advertised

This is nice looking set. It did not have instructions but I have installed many gauges like these before so I knew what to do. The Oil pressure gauge hole for the tubing to slip into was too small and had to be drilled out. The tubing needs to slip in a bit to keep the ferrule away from the end of the tube. Otherwise the connection will leak or even blow off. The Volt gauge electrical connections are very small. Hard to find terminals that are that small. You can wrap bare wire around the posts but that is a bad way to connect it. The mounting bracket comes very close to the terminals and I had to grind away some of the mounting bracket for clearance. The volt gauge reads .6 volts low. The temperature gauge came with an adapter that isn't any size that I recognize. It is too small for 1/2 npt and too big for 3/8 npt. Doesn't even match a metric pipe size. I had to buy an accessory kit for the right adapter fittings. The temperature gauge reads correctly at 180F but is 5F low at 195F.