2 Packs 304 Stainless Steel 3/8"-16 Thread Fully Threaded Rods, 12" Length, Right Hand Threads

Good quality stainless and well machined. Very useful for my project.

Not much to say about this. The threads are well cut and the rods are straight. I generally use this type of material for jigs and furniture construction so I am not overly concerned with strength. At the time of this review, the price was $8 for 2 rods, and frankly there are listings where you can get twice as many for the same price.

These are decent. They'll be good for projects that don't require graded hardware. If you TRULY need all 12" of each rod, don't count on them being ideal. They're fiction cut, and the taper grinds are atrocious. You'll need to redo them.

I am using this for a simple project and it works great. Good threads, no issues with nuts moving on it, seems as rigid as other all threads.

These are genuine 304 stainless threads rods with no burrs, clean threading and well-packaged. Note that ends are rough cut w/ 1/4" heat discoloration from being cut, so for optimal strength plan for max 11.5" final length. (If 100% optimal strength is unnecessary for your application then you just need to finish the ends). I subtracted a star because product photos showed finished ends without heat discoloration. Exactly what i needed — they'll last a long time.

The quality of the threaded rod itself is good. Its straight and cleanly made with good threading. The issue I have is with the cut ends, they are not well formed. As you can see in the picture you may have issues with starting a nut since the thread is mushroomed down. It looks like it was cut and ground down, I needed to clean it up a bit for a nut to thread. Its not a big issue as it can be fixed but its just an additional step you may need to take to use it. There also is some bluing of the metal as if it was heated up.

These threaded rods were 12" as expected and had no manufacturer defects that I could detect. I was worried initially that the threading at the ends may not work because of the way they are cut, but I tested with a nut and all four ends threaded fine.

These threaded rods are as expected. There are no visible defects on either rod. A nut spins freely on the threads over the full length of both rods. When I put a magnet to the rods, there is a slight attraction which is what I'd expect from 304 stainless steel.