G GreatCircleUSA Wood Chipper Shredder Mulcher Replacement Blades for LCE01

GOOD to have for your machine.

Direct replacement intended for the LCE01 chipper that I bought earlier this year. It made a huge difference! Before the replacement, I had to push most branches into the chute, and they would vibrate a lot and sometimes rattle a lot. Now the machine pulls the branch in, sometimes I don't need to push it at all. Also much less vibration and almost no rattling. Installation was 45 minutes. You have to remove a lot of 1/2 inch bolts to get access to both front and back of the blades. Once the hopper is off, the machine wants to tip over, so I put some stone blocks under it for balance. The blades are connected with an alan wrench on front and lock washer / bolt on back. No need to make it extremely tight. Just give it a good tug so the lock washer smashes a bit, and that should do it.

They came on time and are sharp.

Should come with the bolts.

Wood chipping

Shipment arrived ahead of schedule, Assembly was a little difficult because the instructions are not complete but I managed. Used the woodchipper for about 3 hours and it is fantastic. Did not have an issue with it but be warned wear long sleeves and of course gloves. This machine will grab the the small limbs and pull them into the chipper if you don't have long sleeves on your arms will get beat up. Can't say enough about this machine, it is the easiest starting motor I have ever owned and I have owned many over the years.

I pulled up the Great Circle Wood Chipper order receipt I bought two years ago. The recommended blades had two screw holes. However, when I went to install the blades, I noticed that my original GC Wood Chipper's blades had three screw holes and not two. Be careful not to follow the recommended blade parts and check your machine first to ensure the correct blade parts.

It fit my chipper/shredder