New Slimline RAKSEAT014 Quick Release Soft Close WRAP Over Toilet SEAT for Series 600

Easy to fit with all the fixings included - looks good and sturdy

The seat was good quality and reasonably priced. The only fault was the instruction label that was glued to the underside of the lid. It was easy to remove the label but the adhesive was a nightmare to get off. I tried a variety of cleaners and in the end used a bladed scraper to carefully remove the glue, without scratching the lid, that took about half an hour.

This seat fit better than our old one, which I assumed was also by RAK as the bowl and cistern are. The screws needed tightening for quite a while, and more so - and once they seemed to stop rotating, I could usually get it moving a bit more - was worried that I'd over tighten and cause something to break eventually.Soft close works on both seat and lid. It's comfortable to sit on, especially compared to out last seat.The only reason I've removed a star is because the rear 2 feet under the seat don't make contact with the bowl. This was mentioned by only a couple of other reviewers, so it may not occur to most people to check for such a thing, but either the fixings are too tall for this seat, or the feet are too short. If all feet could be about 5mm thicker then this issue would be resolved. I'm just concerned most of our weight is being distributed onto the front feet and they'll damaged over time (which happened to my old seat).

Fab Toilet Seats Ended Up Buying Three Very Good Quality Thank U 😊

Bought as a replacement for the original bottom fixed seat on my 10 year old RAK toilet. The hardest part was removing the original seat as the wing nuts underneath were very difficult to remove having been on for so long (WD40 vital) and I had to lay on the floor to do it. This new seat is made of much sturdier plastic and feels much better quality than the original although it's what I would call winter white in colour, not quite as white as the ceramic. It's very easy to fit but, as others have commented, does take an awful lot of tightening to stop it working loose after a few days. Took me a couple of goes and a lot of elbow grease to get it to stay put but seems okay now. It's easily removed for cleaning by just pressing a button, which makes it much more hygenic. A definite upgrade to the original and makes the loo look like new again!

I bought this to replace an older model seat and lid from RAK Ceramics. This seat is better for a few reasons:1. It's more comfortable. The depressed/concaved seat is far more comfy than the previous one which was convexed.2. It's easier to install3. The soft-close mechanism is built into the seat rather than the hinges4. It's cheaper (the old hinges cost as much as the whole set of seat, cover and hinges here)5. It looks sleeker and more modernThis is a much improved product over the older Series 600 and a recommended purchase, especially as the "original" seat costs twice as much, if not more.

Easy to fit

The system is as good as original well worth money