ShareGoo Metal 12mm to 17mm Wheel Hex Adapter Adaptor Converter Compatible with Tamiya Axial RC4WD Traxxas HPI Himoto HSP Losi Kyosho RC 1/10 On-Road Car Buggy Truck Tyre Tires

Works great on slash axle stubs, I have tekno axles on the rear and barely enough threads to put the nut back on but used thread loctite and hope that will hold them on. Washers are very thin. But overall seams like a decent product but might not work on all trucks. I’m using on a traxxas slash 4x4.EDIT: ran 3 batteries straight with no issues. I think if you use locktite you will be just fine! I’m happy with them!

There was an Issue with one of the adapters. The seller responded to my email within a few hours and a replacement was received a few days after the last email. Great support!

Bought these knowing washers are to small but the adaptors are work great

These are a good cheap upgrade for 17mm conversions. The only reason for knocking a star off is because the washers are a little lousy. They should be a little thicker, or use a stronger metal because the deform easily.

Had to grind down the back side 3mm to get them to fit my sct, which was a pain, but they work.

I used these to mount Traxxas UDR paddles to my Losi Lasernut. I did press out the circular bit, and Dremeled splines so I didn’t have to mess with the expensive wheels. A couple shims so the wheel doesn’t contact the hub and they work great!

This would be a 5 star product if the washer that comes with it had a slightly larger hole, it doesn't allow you tighten the wheel to all the way down.

Great product just strengthen the bond between the round hub and the 17mm end! Will damage hubs. The second pack I've bought the left two are brand new one is already about to break out of the bag and the right two are use the set I was using.