Barkan Long White TV Wall Mount, 13-65 inch Full Motion Articulating - 4 Movement Flat/Curved Screen Bracket, Holds up to 79lbs, Extremely Extendable, Fits LED OLED LCD (BM343XLW)

Measure correctly if you want to view your TV from the extreme left or right. Excellent and heavy duty and as an extra a place to organize rear wires LOVE IT

Strong and lots of mobility! Best bang for your buck!

We have a large TV and love this wall mount. We have used it at a couple of different locations and it works perfectly. You can mount the TV so that it is flat against the wall, tilted, moved, etc.It's a very sturdy, easy-to-use wall mount.

This mount allows my 55" TV to swivel a bit more than 90 degrees, very happy with the range of motion. Like others have mentioned it's a bit difficult to move though, I wish I had lubed the connecting points on the arms when I was installing it, it would be difficult to do now. So I'm happy with the range of motion but it's a bit difficult and awkward to actually move, if I want to swivel it 90 degrees (for my racing sim rig) I have to kind of duck under the TV and/or reach around from the side and actually push the arms because the amount of force required seems like too much to be putting on the TV.The main issue I have, which I figured was going to be an issue just looking at the design before I purchased it, is the TV mount back plate design. If your TV has a 200 X 200 VESA pattern, and especially if the mounting holes are centered on your TV, this mount would be almost perfect. Anything larger than 200 X 200 (my TV is 300 X 200) and you have to use the adapter arms. These arms are attached with one bolt each and as such you can't really ever lock them in place, this makes the TV prone to sagging lower than you had intended with your install and makes it prone to becoming unlevel especially if you are moving it a lot. It's fairly easy to level it again but this will likely cause more sagging and again, you can't really lock it in place so it will likely need to be leveled occasionally.I only had about 6" wiggle room up or down in my mounting location and I mounted it 1" higher than I should have needed to but with all the sagging it's just barely too low now. To be clear the sagging is caused by the backplate adapter arms moving, not from the arms coming from the wall leaning down or being too weak or something. It seems like they could have fixed this issue with one extra piece of metal so you could connect at least 2 of the adapter arms to keep them from moving so much.The install instructions aren't super clear but overall they aren't too hard to decipher, the worst part is trying to figure out the mounting height on your wall as the template and instructions aren't great, especially if your TV has offset VESA holes like mine does.The bolt holes on the wall bracket are also spaced pretty far apart to be side by side and expected to be drilled into the same stud, one of my bolts missed the stud. I used one of the extra holes (for mounting to a different wall material) and angled the bolt a bit and was able to get it into the stud. On the install instructions it looks like the holes are a bit off set diagonally but really they are basically side by side.The tilt design and connecting point from the TV backplate to the mount arms isn't great either but better than most other mounts.In summary, very sturdy, great range of motion, it's the only mount I could find that would allow a 55" TV to swivel a full 90 degrees which I needed. It's also about a third the price of the other mounts that get close to 90 degrees but not quite. If you don't need a full 90 degree swivel I would probably recommend another mount unless your VESA pattern is 200 X 200. If you need the full 90 degrees like I did I think this mount is your best option just be aware of the issues with the backplate adapter arm design that will inevitably cause sagging and make your TV prone to becoming unlevel.

I used this for a 32" HDTV, it worked perfectly to move the TV out from a shelf area where it was originally so that I could tilt it left or right for better viewing

This "Barkan Long White TV Wall Mount, 13-65 inch Full Motion Articulating" is perfect for what we needed it for--bringing our 50" flat screen off of the wall so we can see it head-on from our couch (the opposite wall is french doors). The arm is long enough that if you straighten it completely the TV will sit at a full 90 degrees to the wall. If you are mechanical/handy, it's incredibly easy to install (note: you'll definitely need a good stud finder to find both edges of the stud). If you aren't, the directions are all visual, and not that easy to understand, sonyou might want to find a handy friend or hire someone. Either way, well worth it at the price, and the white one looks quite nice IMO.

I bought this mount because the TV was too big for it's location 😂 it's fine you don't need to go smaller just get the correct mount. The only issue we had was this is an old house and the lumber used is incredibly strong and thick oak which snapped the screws it came with even pre drilling. I like the brackets it came with to keep the cables out of the way and the width was perfect for mounting in two studs.

This is my fourth extendable mount, but the first one I've tried with a single stud mounting. The design of the mount and installation is good, it's very easy to install using a single wall stud. The extension distance from the wall is excellent for a bedroom, this allows for a smaller TV to be extended to right in front of your view. The downsides of the product are a different story, it has a couple of major flaws.1. You CANNOT LEVEL THIS MOUNT no matter what you do. Between being pushed all the way to the wall (closed) and being all the way extended, your level will change by several inches. I can't even understand how it's so bad. You can get it perfectly level either closed or open but not both. Leveling it closed looks the best, but if you extend it for watching it will be noticeable crooked by several inches.2. The bracket on the TV sits on a very small set of metal clips on the wall mount side, I would never attempt the 85 lb listed weight limit specified on this bracket. At best it looks like it can handle 45-50 lbs.

Tiene una calidad muy elevada, instrucciones, accesorios, claidad, es un excelente producto, y en micaso es lo que necesitaba

Es un muy buen producto en el sentido de soporte y estética; sin embargo, montarlo no es fácil, pues los tornillos embonan en los taquetes forzándolos. El brazo es pesado por evidentes razones, así que si lo colocan dos personas, puede facilitarse todo.

Évaluation de l'article- Prix raisonnable- Facile à installer- Solide- Ajustable- Convient parfaitement à ma télévision 55 pouces- Excellent achatJe recommende à tout le mondeÉvaluation du vendeur- Acheté "neuf", mais reçu une boite qui a clairement déjà été ouverte, les collants de protection ont été décollées et la boite de l'article était déchirée par la personne qui l'a ouverte avant moi. Heureusement, l'ensemble des pièces semblent être présentes dans la boite...Évaluation de la livraison- Depuis qu'Amazon n'utilise plus Intelcom comme service de livraison, les instructions de livraison ne sont plus respectés (ma demande n'est pas difficile, c'est de mettre les colis dans le coffre près de la porte principale, j'ai même installé des messages avec des dessins près des portes pour être certain que les livreurs comprennent et déposent les colis au bon endroit.). Depuis que ce n'est plus Intelcom, les colis sont laissés à la vue de tous près de ma sortie de secour et contrairement à Intelcom, il m'est impossible de laisser un commentaire au livreur pour l'informer de son erreur.

Sturdy, solid, fairly priced, what else to ask for? Suited our needs perfectly to have a 43” TV sitting perpendicularly from the wall. Some people complained about the TV tilting down, but since we installed it quite high, the maximal tilt down position is perfect for us and not a problem.During installation in wood stud, at the step where you are screwing the 70 mm screws, it is normal if around 1/3 of the way you can no longer screw! After this point, you MUST use a 11 mm wrench to finish the job (and even with the 11 mm wrench it is quite hard to get the screws fully in, but that’s also what makes the installation solid).Also, when drilling the holes with the provided guide, I recommend to drill the two top holes first. This way, you will be certain that both holes are correctly centred in the stud before drilling the bottom holes. We did the opposite way, only to have one of the top holes not aligned in the stud, which made us lose time + now we have extra holes in the wall. For our second set of holes, we decided to change the vertical position to make sure there is no overlap between old/new sets of holes and it worked like a charm.

Really good quality and strong and easy to fit. Our tv is in a corner and we have various options of movement. Ideal.